![]() ![]() Take care to run wires in a location where they will not interfere Route wires behind torque tube and tack wires in place Opener with insulated staples (not supplied). Uncoil wires from the photoelectric sensors and route wires up the garage walls and along ceiling towards the right side of the opener (see Fig. Select a mounting position, no more than 5 inches above the WALL MOUNTING BRACKETS floor to center line of wall mounting bracket. FOR DOORMASTER, ALSO UNPLUG TELEPHONE CORD TYPE COMMUNICATIONS CABLE. FOR ALL OPENERS, UNPLUG 120 V AC POWER CORD FROM RECEPTACLE. Step 1: Photoelectric Safety Sensor Bracket Installation WARNING DISCONNECT ALL POWER TO “U” BRACKETS GARAGE DOOR OPENER BEFORE SERVICING OR INSTALLING ACCESSORIES OR PHOTOELECTRIC SAFETY SENSORS. ![]() ![]() Table of Contents ○○○○ ○○○○○○○○ Important Safety Instructions For Installation And Use 2. WIRES ARE PRE-ATTACHED Photoelectric Sensors Hardwa Photoelectric Safety Sensors Installation Instructions and Owner’s Manual Wayne-Dalton Corp. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |